TROY Group MICR_IRD M600 Security Printing Solutions series User’s Guide User Manual
Page 60
Section 4
Using the TROY Printer Utility
Security Printing Solutions User’s Guide -- 50-70537-001 Rev. B
4-14
Re-Mapping
Printer Paper
Trays (cont.)
Setting Regional
Options
The following table contains common tray mapping numbers for TROY printers. Due to the Hewlett-Packard
tray assignment scheme, the actual tray number embossed on the paper tray(s) of your TROY printer may not
correspond with the factory tray assignment numbers listed in the table below (e.g., physical tray #2 has a factory
tray assignment number of 3, etc.). Always use the factory tray assignment numbers (listed in the table below)
when re-mapping your printer paper trays using the TROY Printer Utility.
Factory Tray Assignment Numbers
Physical Paper Source (Media)
4014
Printers
4015
Printers
4515
Printers
Paper Tray 1 (manual feed)
4
4
4
Paper Tray 2
1
1
1
Paper Tray 3 (standard on “T” model printers)
5
5
5
Paper Tray 4 (Optional item for all printers)
N/A
8
8
NOTE: The printer’s media source option must be set to Classic to enable the tray-mapping feature. If this option
is disabled in the Security Options screen of the TROY Printer Utility, the factory default tray map settings will be
active. The tray ID numbers shown in the Tray Mapping screen may not represent the actual tray numbers of your
printer. Refer to the Hewlett-Packard Printer User’s Guide for the default paper tray-mapping configuration.
T
O SET THE REGIONAL OPTIONS
:
1. From the Main Window, click on Settings, and
then click on Regional Options.
2. Click on the down-arrow of each selection box to
view the list of available currency and/or decimal
symbol options, and then click on the desired
option. The selected currency symbol will be
used in the audit report, and the selected decimal
symbol will be used for both the audit and secure
seal features.
3. Click on Update Printer to send these settings to
the printer’s flash-file memory, and then click on
OK to continue.