TROY Group MICR_IRD M600 Security Printing Solutions series User’s Guide - Manual (Page 75)

Section 4 Using the TROY Printer Utility
Security Printing Solutions User’s Guide -- 50-70537-001 Rev. B
4-29
The “MICR Adjust X” selection on the printer control panel will move
the MICR line left (negative decipoints) and right (positive decipoints).
The “MICR Adjust Y” selection on the printer control panel will move
the MICR line up (negative decipoints) and down (positive decipoints).
Negative decipoints (move left)
0
Positive decipoints (move right)
Negative decipoints (move up)
Positive decipoints (move down)
Adjusting the
MICR Line
and/or Page
Image
Positioning
(cont.) T O ADJUST THE MICR LINE POSITIONING :
1. From the Main Window, click on Settings, and
then click on ExPT Offsets.
2. Enter the vertical and offset values for the MICR
line and/or image in the appropriate boxes.
These values are represented in decipoints (1/720
of an inch). The valid offset range is –720 to 720
(equals plus/minus one inch). If you are using
the automatic page rotation feature in conjunction
with the ExPT Offsets feature, then you must
adjust the image and MICR offsets accordingly
(see note on previous page).
3. After all values have been entered, click on
Update Printer to send the new settings to the
printer. All previous MICR line and image offset
values in the printer will be overwritten. The
system will prompt you with “Print Quality Document to verify adjustments?” Click on Yes to print the
quality document, or click on No to proceed without printing the quality document.
4. When closing the ExPT
Offsets window, the
system will prompt you
with “Do you want to save
changes to ExPT Offset
values?” Click on Yes to
save the new offset values
in a user-named file for
future use (e.g., Acme
print job offset
values.ops), or click on No
to continue without saving
the new offset values.