VTech SN6187 Abridged manual - Manual (Page 107)

Appendix
100
Energy-saving charging mode
When this mode is activated, all telephone functions, except
handset battery charging, will be disabled.
To activate the energy-saving charging mode:
Unplug the telephone base power adapter from the
power outlet. Make sure all handsets are plugged with
charged batteries.
While you press and hold
/FIND HANDSET, plug the
telephone base power adapter back to the power outlet.
After about 20 seconds, when the
IN USE light starts
flashing, release /FIND HANDSET and then press it again
within 2 seconds.
When the phone successfully enters the energy-saving
mode, the IN USE light turns off and all handsets
display To register HS, see manual.
When the phone fails to enter this mode, repeat Step 1
through Step 3 above.
Note: The telephone base will be powered up as normal if
you fail to press /FIND HANDSET within 2 seconds in
Step 3.
To deactivate the energy-saving charging mode:
Unplug the telephone base adapter from the power outlet,
then plug it back in. Then the telephone base is powered
up as normal.
Register your handset and pendant back to the telephone
base. See pages 15 and 16 for registration instructions.
1.
2.
3.
1.
2.