VTech SN6187 Abridged manual - Manual (Page 90)

Appendix
83
Troubleshooting
Out of range OR Base no power appears on my
cordless handset.
Ensure you plug the telephone base in properly and
the power is on.
Place the cordless handset closer to the telephone
base for synchronization.
Move the cordless handset closer to the telephone
base. You may have moved out of range.
Reset the telephone base. Unplug the electrical
power. Wait for 15 seconds then plug it back in.
Allow up to one minute for the cordless handset and
telephone base to reset.
Other electronic products such as HAM radios and
other DECT phones can cause interference with your
cordless phone. Try installing your phone as far away
as possible from these types of electronic devices.
The handset battery does not accept charge
while in the telephone base or handset charger.
If the cordless handset is in the telephone base or
handset charger and the charge light is not on, refer
to The charge light is off on page 89.
Charge the battery in the cordless handset for at least
11 hours. For optimum daily performance, return the
cordless handset to the telephone base or handset
charger when not in use.
•
•
•
•
•
•
•