VEGA VEGASON 66 Profibus PA User Manual
Page 17
1
2
3
4
5
Fig. 6: Mounting - Version C
1
Groove for locking the connection head
2
Marking notch
3
Screw of swivelling holder (hexagon SW 13)
4
Grub screw, fixing ring (hexagon spanner - size 4)
5
Terminal screws, connection head (hexagon spanner - size 4)
Version D is supplied in three parts: Transducer, transducer
cable and electronics for wall mounting.
Assemble the version as follows:
1 Loosen the hexagon nut (3) on the transducer cable
2 Insert the transducer tube from below into the mounting
opening G1 A
3 Fasten (SW 46) the hexagon nut (3)
4 Remove the plug from below out of the connection head
and plug it into the socket of the transducer tube
5 Plug the connection head to the transducer tube. Do not
squeeze any cables. The cylinder is in the correct position,
if the lower notch (2) of the transducer tube is no longer
visible
6 Tighten the screws (4) on the cylinder moderately with a
hexagon spanner (size 4)
Mounting - Version D
VEGASON 66 - Profibus PA
17
Mounting
28789
-EN
-060731