VEGA VEGASON 66 Profibus PA - Manual (Page 29)

6 Setup with the indicating and
adjustment module PLICSCOM
6.1 Short description
The indicating and adjustment module PLICSCOM is used for
measured value display, adjustment and diagnosis. It can be
mounted in the following housing versions and instruments:
l
All sensors of the plics ® instrument family, in the single as
well as in the double chamber housing (optionally in the
electronics or connection compartment)
l
External indicating and adjustment unit VEGADIS 61
Note:
You will find detailed information on the adjustment in the
operating instructions manual of the "Indicating and adjustment
module PLICSCOM".
6.2 Insert the indicating and adjustment module
The indicating and adjustment module can be inserted in the
sensor and removed at any time. It is not necessary to interrupt
the voltage supply.
Proceed as follows:
1 Unscrew the housing cover
2 Place the indicating and adjustment module in the desired
position on the electronics (you can choose any one of four
different positions - each displaced by 90°)
3 Press the indicating and adjustment module onto the
electronics and turn it to the right until it snaps in.
4 Screw housing cover with inspection window tightly back
on
Removal is carried out in reverse order.
The indicating/adjustment module is powered by the sensor,
an additional connection is not necessary.
Function/Configuration
Mounting/dismounting the in-
dicating and adjustment
module
Setup with the indicating and adjustment module PLICSCOM
VEGASON 66 - Profibus PA 29
28789
-EN
-060731