VEGA VEGAWAVE 62 Cable shortening set User Manual
Page 12
6
9
12
10
7
30mm
(1
3
/
16
")
100 mm
(3
15
/
16
")
Fig. 9: Shorten suspension cable - shift cable clamp
6
Pins
7
Cable clamp
10 Breaker plate
12 Suspension cable
17 Plug the breaker plate (10) on the bare suspension cable
(12) and lead the 4 wires (green, yellow, red, green-yellow)
separately through the outer holes of the breaker plate
(10).
Do not lead the fawn plastic cords (11) through the breaker
plate.
18 Shift the cable clamp (7) flush to the suspension cable (12).
When shifting, turn the cable clamp in the direction of the
cable drilling to avoid splicing the wire. The chamfered side
facilitates inserting the suspension cable.
19 Tighten the pins (6) constantly on all sides with an Allen
wrench 2 mm. The pins should be screwed in with the
same depth into the cable clamp (approx. 3 Nm / 2.2 lbf ft).
20 Cut the fawn plastic cords (11) as short as possible with a
wire cutter.
21 Remove the insulation of the screened green (GN) and
yellow (YE) wire on a length of 60 mm (2.4 in). Slightly push
back the screen braiding and open it with a sharp object in
the rear section.
Make sure that the wires are not damaged.
12
VEGAWAVE 62 - Cable shortening set
Mounting
32361
-EN
-060822