VEGA VEGAWAVE 62 Cable shortening set User Manual
Page 15
14
A
B
Fig. 14: Mount the vibrating element
14 Pressure screw
A
Upper part of the oscillator
B
Lower part of the oscillator
27 Mount the parts of the vibrating element. Clamp the lower
part of the oscillator (B) into the bench vice and turn only
the upper part of the oscillator (A). The cable must not turn.
28 Pull the cable (9) to the top and push the seal rings (18)
and the washer (17) in the upper part of the oscillator (19).
29 Shift the pressure screw (14) and the pressure ring (15) on
the rubber jacket (16).
18
17
14
15
16
19
Fig. 15: Cable seal
14 Pressure screw
15 Pressure ring
16 Rubber jacket
17 Washer
18 Rubber rings
19 Upper part of the oscillator
30 Provide the pressure screw (14) with screw retention
lacquer and screw it into the upper part of the oscillator
(19).
31 Tighten the pressure screw (14) with the flat wrench SW 24
(approx. 6 Nm/4.4 lbf ft).
32 Check length of the sensor.
VEGAWAVE 62 - Cable shortening set
15
Mounting
32361
-EN
-060822