VEGA VEGAWAVE 62 Cable shortening set User Manual
Page 8
Advertising
L
neu
L
145 mm
(5
45
/
64
")
9
Fig. 2: Cut the cable with a bolt cutter
9
Cable
5 Cut the cable (9) with a bolt cutter approx. 145 mm
(approx. 5.7 in) above the new sensor length (L).
6 Clamp the upper part of the oscillator (19) in to the bench
vice.
14
9
Fig. 3: Unscrew pressure screw
9
Cable
14 Pressure screw
7 Remove pressure screw (14) with the flat spanner SW 24
so that the cable does not turn with the following
dismounting.
8 Clamp the lower part of the oscillator (below the screwed
separating position) into the bench vice.
Do not clamp on the fork tines
8
VEGAWAVE 62 - Cable shortening set
Mounting
32361
-EN
-060822
Advertising