VEGA VEGAWAVE 62 Cable shortening set - Manual (Page 7)

4.2 Mounting sequence
1 2 3 4
7 6 5
Fig. 1: Cable shortening set for VEGAWAVE 62
1 Crimp connector yellow, 2 pcs., article no. 2.11444
2 Crimp connector red, 3 pcs., article no. 2.18710
3 Crimping sleeve blue À8 x 30 mm, 1 pce., article no. 1.243
4 Crimping sleeve black À3 x 55 mm, 1 pce., article no. 1.1207
5 O-rings À37 x 2 mm, 2 pcs., article no. 2.28878
6 Pins M4 x 6, 4 pcs., article no. 2.28894
7 Cable clamp À12 x 20 mm, 1 pce., article no. 2.28876
The numbers refer to the figures on the following pages.
1 Interrupt the voltage supply of the sensor and remove
connection cable.
2 Dismount the sensor.
3 Clean the cable (9) of the sensor.
4 Determine new sensor length (L) with a tape measure
according to the illustration and mark with the marker.
You find information on the sensor length (L) in the
operating instructions manual of the sensor.
Mounting
VEGAWAVE 62 - Cable shortening set 7
Mounting
32361
-EN
-060822