5 master/slave function – VEGA VEGATOR 632 User Manual
Page 28
If you are using a probe without line break monitoring, a fault signal will
be triggered. In this case, set the switch (7) to off.
Only failures of channel 1 are monitored.
A failure is signalled via the red control lamp on the front plate.
Alarm
off on
1
2
3
4
5
6
7
Fig. 57: Switch block (A) with switch (7) for activation of the line break monitoring
(alarm)
You find detailed information on how to trigger a fault signal via the
second relay output in the previous chapter "Adjust relay function".
7
.5 Master/Slave function
Adjust the instrument as Master with switch 8 of the DIL switch block
(A).
Definition of the instru-
ment as Master or Slave
(DIL switch block A)
28
VEGATOR
632 • Signal conditioning instrument
7 Set up - Single channel control (level detection)
35243
-EN
-120228