VEGA VEGATOR 632 - Manual (Page 41)

10 Set up - Four-channel control
10 .1 General information
You require two VEGATOR 632 signal conditioning instruments for a
four-channel control.
10 .2 Adjust relay function
Depending on the switching function of the signal conditioning
instrument.
See single channel, two-point or two-channel control.
10 .3 Adjustment
Depending on the switching function of the signal conditioning
instrument.
See single channel, two-point or two-channel control.
10 .4 Adjust switching delay
See single channel, two-point or two-channel control.
10 .5 Activate line break monitoring
The line break monitoring or alarm function defines the function of the
instrument in case of failure.
If you are using a probe without line break monitoring, a fault signal will
be triggered. In this case, set the switch (7) to off.
Only failures of channel 1 are monitored.
A failure is signalled via the red control lamp on the front plate.
Alarm
off on
1
2
3
4
5
6
7
Fig. 130: Switch block (A) with switch (7) for activation of the line break
monitoring (alarm)
VEGATOR 632 • Signal conditioning instrument 41
10 Set up - Four-channel control
35243
-EN
-120228