VEGA VEGAWELL 72 4 … 20 mA_HART PT 100 - Manual (Page 6)

D uring the entire duration of use, the user must make sure that
the occupational safety measures taken always comply with
current valid policy as well as new regulations.
2 .5 Safety approval markings and safety tips
T
he safety approval markings and safety tips on the device
must be observed.
2 .6 CE conformity
T he protection goals of the EMC Directive 2004/108/EC (EMC)
and the Low Voltage Directive 2006/95/EC (LVD) are fulfilled.
C
onformity has been judged according to the following
standards:
EMC: EN 61326-1: 2006
(
electrical instruments for control technology and laboratory
use - EMC requirements)
l
E
mission: Class B
l
S usceptibility: Industrial areas
LVD: EN 61010-1: 2001
(
safety regulations for electrical measurement, control and
laboratory instruments - part 1: General requirements)
2 .7 Fulfilling of NAMUR recommendations
W
ith respect to interference resistance and emitted interfer-
ence, the NAMUR recommendation NE 21 is fulfilled.
W ith respect to compatibility, the NAMUR recommendation
NE 53 is fulfilled. This applies also to the corresponding
indicating and adjustment components. VEGA instruments are
generally upward and downward compatible.
l
S
ensor software for DTM VEGAWELL 72 HART
l
DTM VEGAWELL 72 for adjustment software PACTware
T he parameter adjustment of the basic sensor functions is
independent of the software version. The range of available
functions depends on the respective software version of the
individual components.
T
he software version of the instrument can be read out via
PACT ware.
6 VEGAWELL 72 • 4 … 20 mA/HART PT
2 F or your safety
34360
-EN
-080806