VEGA VEGAPULS 68 (≥ 2.0.0 - ≥ 4.0.0) Profibus PA - Manual (Page 13)

13
3 Product description
VEGAPULS 68 • Profibus PA
36537-EN-130205
ment of plics ® sensors. The adjustment is carried out via PACTware/
DTM by using the integrated USB connection.
You can find further information in the supplementary instructions
"PLICSMOBILE T61" (Document-ID 36849).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, ANSI B 16.5, JIS B 2210-
1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
The electronics module VEGAPULS series 60 is a replacement part
for radar sensors of VEGAPULS series 60. There is a different version
available for each type of signal output.
You can find further information in the operating instructions "Electro-
nics module VEGAPULS series 60" (Document-ID 36801).
The antenna impedance cone is used for optimum transmission of
microwaves and for sealing against the process.
You find further information in the operating instructions "Antenna
impedance cone VEGAPULS 62 and 68" (Document-ID 31381).
Flanges
Protective cover
Electronics module
Antenna impedance cone