VEGA WHA-GW-WIRELESSHART GATEWAY - Manual (Page 76)

22
1981
2011
-0
7
76
WHA-GW-*
Operation
6.3.3 Set DTM address
The table in the Set DTM address window shows the WirelessHART devices configured in
the PACTware project and their DTM addresses. The DTM address is the device long tag
as specified in the device's DTM (offline data record). The DTM address is also displayed in
the project tree structure of the PACTware project.
Figure 6.10Additional Functions > Set DTM address
Changing the DTM address
1. Place the cursor inside a cell of the Long Tag column.
2. Change the device long tag as required. You may change the long tags of several
devices at once, if needed.
3. Close the DTM dialogs of the devices whose long tags are to be changed.
4. To apply the new DTM address(es) press Update changed tags.
The new DTM addresses are displayed in the project view of PACTware.
Note!
The Device Long Tag parameterized in the Set DTM Address window must be identical
with the Device Long Tag of the same device parameterized in the Set Device Address
window (see chapter 6.3.4). Otherwise the DTM is not able to establish a connection to the
device.