Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 301)

GPRS Commands
Automatic Response to a Network Request for PDP Context Activation +CGAUTO
©Restricted
Page: 111 / 156
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 2 August 23, 2007
14.11.3 Parameters and Defined Values
<n>:
automatic response mode
0 turn off automatic response for GPRS only
GPRS network requests are manually accepted or rejected by
the +CGANS command.
1 turn on automatic response for GPRS only
GPRS network requests are automatically accepted.
2 Wireless CPU ® compatibility mode, GPRS only
Automatic acceptance of GPRS network requests is controlled
by the "S0" command. Manual control uses the "A" and "H"
commands, respectively, to accept and reject GPRS requests
(+CGANS may also be used). Incoming circuit switched calls
can be neither manually nor automatically answered.
3 Wireless CPU ® compatibility mode, GPRS and circuit switched
calls (default value)
Automatic acceptance of both GPRS network requests and
incoming circuit switched calls is controlled by the "S0"
command. Manual control uses the "A" and "H" commands,
respectively, to accept and reject GPRS requests (+CGANS
may also be used).
14.11.4 Parameter Storage
The <n> parameter is stored in EEPROM using the AT&W command. The default
value can be restored using AT&F.
14.11.5 Examples
Command Responses
AT+CGAUTO=? +CGAUTO: (0-3)
OK
AT+CGAUTO=2 OK
AT+CGAUTO? +CGAUTO: 2
OK