Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 565)

Audio Commands
Side Tone Modification +SIDET
©Restricted
Page: 17 / 158
This document is the sole and exclusive property of Wavecom. Not to be distributed or divulged without
prior written agreement.
WM_DEV_OAT_UGD_049 - 001 VOLUME 4 August 23, 2007
21.5 Side Tone Modification +SIDET
21.5.1 Description
This Wavecom proprietary command is used to set the level of audio feedback in the
speaker (microphone feedback in the speaker).
21.5.2 Syntax
Action command
AT+SIDET=<val1>[,<val2>]
OK
Read command
AT+SIDET?
+SIDET: <val1>,<val2>
OK
Test command
AT+SIDET=?
+SIDET: (list of supported <val1>s),(list of supported <val2>s)
OK
21.5.3 Parameters and Defined Values
<val1>:
side tone mode
0 side tone is disabled
1 side tone is enabled (default value)
<val2>: side tone level
range: 0-63 (default value : 25)
21.5.4 Parameter Storage
The <val1>and <val2> parameters are stored in EEPROM using the AT&W
command. The default values can be restored using AT&F and AT+VIP=1.