SENA STS Series - Manual (Page 51)

51
4.2.5. Remote Host Configuration
Remote host configuration is the list of hosts that will receive data from serial port of STS Series when
there is data transmission from a serial port of STS Series.
In TCP mode, user can also configure secondary remote host that will receive data from serial port if
STS Series fails to connect to primary remote host. But if connection to primary remote host can be
made, STS Series dose not send data to secondary remote host until connection to primary remote
host failed. And the maximum possible number of primary remote host is limited up to 16.
In UDP mode, user can configure only primary remote host because there is no way for STS Series to
check status of primary remote host, so secondary remote host is meaningless.
Figure 4-8 shows Remote host configuration pages of the Web UI. (TCP mode)
Figure 4-8 Remote host configuration
4.2.6. Port IP Filtering Configuration
The remote hosts that are allowed to access the STS Series serial ports can be specified based on the
IP address filtering rules. The user may allow specific hosts to access the STS Series serial ports by
providing a valid IP address or network address and its subnet mask. Please refer to section 3.5. IP
Filtering for more details.