SENA STS Series - Manual (Page 71)

71
The user must manually select PC LAN card as the card type and set the primary and secondary DNS
servers when configuring a PC LAN card. All other configuration steps are the same as detailed in
Section 3.1 IP Configuration.
Refer to Appendix 2.PC Card Supported By STS to view a list of LAN PC cards supported by the STS
Series.
5.2. Wireless LAN Card Configuration
A wireless LAN card will result in two network interfaces and two IP addresses. The user can assign a
valid IP address to each serial port. The IP address must valid in the STS Series built-in network
interface or in the wireless LAN interface environment.
Figure 5-4 PC wireless LAN card configuration
The user must manually select WIRELESS LAN CARD as the card type and set the primary and
secondary DNS servers when configuring a PC LAN card. All other configuration steps are the same
as detailed in Section 3.1 IP Configuration.