SENA STS Series - Manual (Page 70)

70
Figure 5-2 Failure to detect error message
Refer to Appendix 2. PC Card Supported By STS to view a list of PC cards support by the STS Series.
To stop or remove the PC card, user must complete the following steps.
Step 1. Select [(Ban- show the actual button) Stop card service].
Step 2. Save the configuration changes by selecting [Save to flash].
Step 3. Apply changes by selecting [Apply changes] from the menu.
Step 4. Remove the PC card from the PC card slot.
Note: Removing the PC card from the slot without following the above instructions may cause a
system malfunction.
5.1. LAN Card Configuration
A LAN card will create two network interfaces and two IP addresses. The users can assign a valid IP
address to each serial port. The IP address must be valid in the STS Series built-in network interface
or the environment of STS Series PC card LAN interface environment.
Figure 5-3 PC LAN card configuration