GE Industrial Solutions EntelliGuard R AKD-6 - Manual (Page 22)

21 EntelliGuard R Circuit Breaker Retrofill AKD-6 Installation Manual DEH-41548 02/12
Typical wiring diagrams for the AKD-6 are given below ( Figure 10 ).
Figure 10. Typical AKD-6—Wiring Diagrams for the Secondary Disconnect Bullets
Example: Retrofill EntelliGuardACB (AKR30/30H/50/50H/30L)
Example: Retrofill EntelliGuard ACB (AKR30S)
Install Position Switch Actuator (Breaker)
Position switch actuator bracket can be installed on all versions of Retrofill EntelliGuard ACB for AKD6 LVS
(
Figure 11 ). The steps of installation are as follows:
Retrofills use the legacy position switch already mounted in the cubicle. If a new position switch has to be installed,
refer to the legacy position switch installation manual.
1. Unpack the position switch bracket. Each bracket is provided with a pair of M6x16mm Allen-type bolts and
washers.
2. Place the bracket on the bottom right side of the AKD6 base. Two locating holes are provided for mounting
of the position switch bracket.
3. Fasten the two bolts to the locating holes after placing the washers to securely mount the bracket.
4. The bracket is ready for use.