GE Industrial Solutions EntelliGuard R AKD-6 User Manual
Page 38
Advertising
37
EntelliGuard R Circuit Breaker Retrofill AKD-6 Installation Manual DEH-41548 02/12
Figure 29. AKD-6—Slide the Inner Frame (Dimensioning)
8. Place the programmer disconnect assembly on the mounting holes (
Figure 30)
and secure it to the base of the
programmer using hardware (Bolt—M6 X 35, Nut—M6 (metric)) provided along with the programmer
disconnect assembly kit.
9. Check the movement of programmer disconnect on slides for biasing.
10. Tighten the hardware hand-tight (
Figure 31
).
11. From the disconnect plug, route the wire to suitable incoming cables from the compartment.
Figure 30. AKD-6—Holes Drilled for Mounting
Programmer Disconnect
Figure 31. AKD-6—Programmer Disconnect Assembly
Secured in Place
Advertising