GE Industrial Solutions Entellisys 4.0 System Test Kit User Manual - Manual (Page 20)

System Test Kit 20
1.5.1.1 System Configuration Download Link communication
The test kit communicates with the HMI over the System Configuration Download Link. This link
is a USB-to-USB Network Bridge-Ethernet connection. The IP addresses are programmed by
default into the test kit and the HMI and should not be changed. Download failure will result if
these IP addresses are mismatched.
•
Default HMI USB-to-USB Network Bridge IP address is 192.168.2.50.
•
Default test kit USB-to-USB Network Bridge IP address is 192.168.2.25.
The HMI’s IP address must be set in the test kit. To verify this is set properly, from the HMI Setup
screen, go to the Test Kit Administration.
1.5.2 Last Download
Select this option to download the previously downloaded switchgear lineup configuration.
Figure 1-10 Process to download previous settings
Care should be taken before deciding to use previously downloaded settings.
•
Is this the same lineup that was downloaded previously?
•
Has anything changed since the configuration was downloaded previously?
NOTE: Mismatch in configuration and/or settings will result in incorrect test results.