GE Industrial Solutions Entellisys 4.0 System Test Kit User Manual - Manual (Page 31)

Test Menu 31
Figure 1-15 Automatic trip time curve test
Quick Test Guide
1. Enter Operator Name and Test Description.
2. Select a Breaker.
3. Select Breaker Trip or No Trip Test.
4. Select Ground Fault Defeat or Resume depending on Fault Phase(s) desired.
5. Select the Curve Type.
6. Select the Fault Phase.
7. Click Perform Test.
Test setup field description
Table 1-8 Test setup field description
Test Name Unique test identifier, assigned by the test kit, generated by the type of
test selected and the date the test is performed.
Operator Operator name entered by the Test Operator. (20-character limitation)
Test Description Test description entered by the operator, to be stored in the log file.
(150-character limitation)
Breaker Selection Circuit Breaker to be tested, selected by the operator.
Compartment # Compartment number of the circuit breaker selected.