GE Industrial Solutions Entellisys 4.0 System Test Kit User Manual - Manual (Page 56)

System Test Kit 56
1.12.4 Test Kit Validation Test
This feature provides internal tests to validate the test kit hardware.
Figure 1-27 Test Kit Validation screen
1.12.4.1 Customer Validation Tests
These tests are provided for the customer to validate the test kit hardware. The pre-set tests
check both the analog output and the digital output signals.
To perform tests
1. Remove the “Test Kit Output Connector” from the Messenger.
2. Press Perform Test.
NOTE: Remove the test kit connector from the Messenger during Test Kit Validation tests to
prevent false results and to prevent test signals from being injected into the Messenger.
Test Results
The results are summed up in the two LED indicators on the left-hand side of the screen.
•
Green = Pass (indicating the hardware is working properly).
•
Red = Failure (indicating there is a hardware problem). More detailed data is available on the
left-hand side. For any failures, contact GE Post Sales Service for technical help (see
How to
contact us on page 2 ).