GE Industrial Solutions LP 33 Series 50 & 60 kVA Operating Manual - Manual (Page 30)

Modifications reserved Page 30/57
OPM_LPS_3UO_50K_60K_0US_V010.doc Operating Manual LP 33 Series 50 & 60 kVA
6.3 MENU SCREENS (Menu)
Pressing the menu keypad a series of screens will be displayed, permitting the user to set some
functions of the UPS, to restore the command total off, to perform the LEDs TEST, and to switch the
inverter ON/OFF.
LP 33 60kVA P1
UPS ON
1. UPS family, nominal rating and for RPA: P + No. UPS.
2. The operating mode of the UPS (UPS ON/OFF).
COMMAND MENU
INVERTER ON *
INVERTER OFF
1. Screen inverter command.
2. Inverter ON.
3. Inverter OFF.
(The visualization of *, indicates the Inverter status).
LAMP TEST
RESET TOTAL OFF
*
1. Signaling LEDs test and buzzer test.
2. Restore the output supply following the command total off
(the asterisk * beside the text means that the command total
off has been activated with Q1 closed).
PARAMETER MENU
LEVEL 1: USER
LEVEL 2: SERVICE
1. Screen parameters set-up for user and service.
3. Level 1: this first level not protected by password allows
the user to modify some parameters of the UPS
(see Section 6.3.1).
4. Level 2: access protected by password reserved for service
engineers.
ALARMS
UPS FAILURE
CALL SERVICE
1. Screen indicating the presence of alarm condition and the
consequent operation mode.
2. UPS status: UPS shutdown due to UPS FAILURE (fuse blown) or
abnormal conditions for UPS (OVERTEMPERATURE or MAINS
FAILURE).
3. Action needed following the alarm condition CALL SERVICE or
output statement which can be APPLIC.
ON UTILITY if the output is powered by mains or
APPLIC. PROTECTED when the load is normally powered by
the inverter.