GE Industrial Solutions LP33 Series 80 & 100 User Manual - Manual (Page 27)

Modifications reserved Page 27/66
OPM_LPS_3UO_80K_M10_1US_V010.doc User Manual LP33 Series 80 & 100 UL S1
` Home\Meter
UTILITY
f 60 Hz
L1 120 V
L2 120 V
L3 120 V
BYPASS FREE
Bypass utility data screen
f The frequency of the utility.
L1
L2 3-phase utility voltage PHASE /NEUTRAL.
L3
Bypass Bypass status: FREE / LOCKED.
` Home\Meter
INVERTER
f 60 Hz
L1 120 V
L2 120 V
L3 120 V
T OK
SYNCHRONIZED
Inverter data screen
f The output frequency of the Inverter.
L1
L2 3-phase output voltage PHASE/NEUTRAL.
L3
T The temperature of the inverter bridge (OK / MAX).
The synchronization status of the inverter with respect to
utility (Synchronized / Not Synchronized).
` Home\Meter
MODULE LOAD
L1 : 120 V 139.0 A 50 %
L2 : 120 V 139.0 A 50 %
L3 : 120 V 139.0 A 50 %
LOAD ON INVERTER
Module load screen
… V Output voltage PHASE/NEUTRAL for each phase.
… A The output current as RMS values (RPA: value for
each UPS).
… % The output load as percentage (RPA: value for each
UPS).
The source of the power supplied to the load.
` Home\Meter
COUNTERS
Bypass utility failure : 53
Rectifier utility failure : 35
Overloads : 15
InvOperTime [h] : 2135
UPSOperTime [h] : 3125
Statistics screen
The total number of minor utility faults (bypass utility out of
tolerance faults).
The total number of times a gap of utility in the rectifier has
been reordered.
The total number of detected output overloads.
The total operating time for the Inverter (in hours).
The total operating time for the UPS (in hours).
` Home\Meter
UTILITY
NUMBER OF FAST TRANSIENTS
<2ms >2ms >5ms >10ms
25 20 7 5
ECO MODE RATE = 70 %
ECO Mode statistic screen
This screen is enabled only for a single UPS, not for an RPA
Parallel System.
The number of fast transients occurred on the bypass
utility in the last seven days.
The statistic evaluation in % (100= good; 0= bad) of the
utility, for the ECO mode operation.