GE Industrial Solutions AF-300 P11 - Manual (Page 117)

9-2
Data subject to change without notice 7/07. © 2007 GE Drives
IN-WARRANTY FAILURE CHECKLIST
To assist with warranty troubleshooting, the following information is required. This data is needed to evaluate the
cause in an effort to eliminate any further failures.
Model No.: ______________________________________________________________________
Serial No.: ______________________________________________________________________
Start-Up Date: __________________________________________________________________
Failure Date: ____________________________________________________________________
Status When Failure Occurred (check one):
Power-Up __________ Running ___________ Accel ___________ Decel _________
Explanation of Failure ____________________________________________________________
Application Information (check Yes or No)
Input Transformer: Yes ___________ No _______________
If Yes: KVA ___________________________________
L1 Volts ___________ L2 Volts ________ L3 Volts ______________
Power Factor Correction Capacitors: Yes __________ No _______________
If Yes: Microfarrad ______________________________
Other Equipment on Same Power Yes __________ No _______________
If Yes, what?
Line Reactor on Input Yes __________ No _______________
Input Starter Yes __________ No _______________
Output Starter Yes __________ No _______________
Motor Overloads Yes __________ No _______________
Control Terminals Used (circle if used)
Function Codes Different From Factory Settings
Function Code Setting Function Code Setting
Failure Message (see Section 4)
Latest Fault _______________ Previous Faults: No Message _____________
Hz ______________________ 1. _____________________________
A _______________________ 2. _____________________________
V _______________________ 3. _____________________________
After all of the Checklist information is acquired, contact the following number for assistance: (800) 533-5885
When returning failed parts, reference the C_ _ _ _ # on the shipping documents that came with the replacement parts and ship
failed parts to: GE Drives.
(Marked C _ _ _ _ #)
30C 30B Y5C
Y4 Y2 11 12 13 V2 CM CM
FWD REV P24 P24 DX DX SD
30A Y5A CMY
Y3 Y1 C1
FMA FMP PLC
X1 X2 X3 X4 X5 X6 X7 X8 X9