Asus Pundit P2-PE2 - Manual (Page 20)

2 - 4 2 - 4 2 - 4 2 - 4 2 - 4 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
2. Use the metal cover
handle to slide the cover
toward the rear panel
until the side hooks
disengage from the HDD
metal tray and optical
drive shield tabs.
Lift the metal cover,
then set aside.
3. Connect the 40-pin IDE
cable to the IDE
connector on the drive.
4. Connect the 4-pin power
plug to the HDD power
connector.
Set your hard disk drive as Master device before connecting the IDE
cable and power plug. Refer to the HDD documentation on how to set
the drive as Master device.
2.4 Installing a hard disk drive (HDD)
The system supports one UltraATA133 IDE hard disk drive (HDD).
To install a hard disk drive:
1. Remove the two metal
cover screws. Keep the
screws for later use.
H a n d l e H a n d l e H a n d l e H a n d l e H a n d l e
S i d e h o o k s S i d e h o o k s S i d e h o o k s S i d e h o o k s S i d e h o o k s
S i d e h o o k s S i d e h o o k s S i d e h o o k s S i d e h o o k s S i d e h o o k s
A A A A A
B B B B B
3 3 3 3 3
1 1 1 1 1
4 4 4 4 4