Asus Pundit P2-PE2 - Manual (Page 63)

5 - 1 5 5 - 1 5 5 - 1 5 5 - 1 5 5 - 1 5 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2
After entering the IDE hard disk drive information into BIOS, use a disk
utility, such as FDISK, to partition and format new IDE hard disk drives.
This is necessary so that you can write or read data from the hard disk.
Make sure to set the partition of the Primary IDE hard disk drives to
active.
Cylinders Cylinders Cylinders Cylinders Cylinders
Configures the number of cylinders. Refer to the drive documentation to
determine the correct value.
H e a d H e a d H e a d H e a d H e a d
Configures the number of read/write heads. Refer to the drive documentation
to determine the correct value. To make changes to this field, set the IDE
Primary Master field to [Manual] and the Access Mode to [CHS].
Sector Sector Sector Sector Sector
Configures the number of sectors per track. Refer to the drive
documentation to determine the correct value.
CHS Capacity CHS Capacity CHS Capacity CHS Capacity CHS Capacity
This field shows the drive’s maximum CHS capacity as calculated by the
BIOS based on the drive information you entered.
Maximum LBA Capacity Maximum LBA Capacity Maximum LBA Capacity Maximum LBA Capacity Maximum LBA Capacity
This field shows the drive’s maximum LBA capacity as calculated by the
BIOS based on the drive information you entered.
PIO Mode PIO Mode PIO Mode PIO Mode PIO Mode
Sets the PIO mode. Configuration options: [Auto] [Mode 0] [Mode 1]
[Mode 2] [Mode 3] [Mode 4]
Ultra UDMA Mode Ultra UDMA Mode Ultra UDMA Mode Ultra UDMA Mode Ultra UDMA Mode
Sets the Ultra UDMA transfer mode. Configuration options: [Disabled]
[Auto]