Asus Pundit P2-PE2 - Manual (Page 66)

5 - 1 8 5 - 1 8 5 - 1 8 5 - 1 8 5 - 1 8 C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p C h a p t e r 5 : B I O S s e t u p
USB Legacy Support [Auto] USB Legacy Support [Auto] USB Legacy Support [Auto] USB Legacy Support [Auto] USB Legacy Support [Auto]
Setting to [Auto] allows the system to detect a USB device at startup. If
detected, the USB controller legacy mode is enabled. If not detected, the
USB controller legacy mode is disabled. When you set this field to
[Disabled], the USB controller legacy mode is disabled whether or not you
are using a USB device. Configuration options: [Auto] [Disabled] [Enabled]
5.4.1 5.4.1 5.4.1 5.4.1 5.4.1 Chip Configuration Chip Configuration Chip Configuration Chip Configuration Chip Configuration
SDRAM Configuration [By SPD] SDRAM Configuration [By SPD] SDRAM Configuration [By SPD] SDRAM Configuration [By SPD] SDRAM Configuration [By SPD]
Allows you to set the optimal timings for items 2 to 5, depending on the
memory modules that you are using. The default setting is [By SPD], which
configures items 2 to 5 by reading the contents in the SPD (Serial Presence
Detect) device. The EEPROM on the memory module stores critical
information about the module, such as memory type, size, speed, voltage
interface, and module banks. Configuration options: [User Defined]
[By SPD]
The SDRAM parameters (items 2 to 5) are user configurable only when
you set the SDRAM Configuration to [User Defined].
SDRAM CAS Latency [2.5T] SDRAM CAS Latency [2.5T] SDRAM CAS Latency [2.5T] SDRAM CAS Latency [2.5T] SDRAM CAS Latency [2.5T]
Controls the latency between the SDRAM read command and the time the
data actually becomes available. Configuration options: [2.5T] [2T] [1.5T]
[3T]