Asus Pundit P2-PE2 - Manual (Page 71)

5 - 2 3 5 - 2 3 5 - 2 3 5 - 2 3 5 - 2 3 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2
Video Off Method [DPMS OFF] Video Off Method [DPMS OFF] Video Off Method [DPMS OFF] Video Off Method [DPMS OFF] Video Off Method [DPMS OFF]
Defines the video off features. The Display Power Management System
(DPMS) feature allows the BIOS to control the video display card if it
supports the DPMS feature. [Blank Screen] only blanks the screen. Use this
for monitors without power management or “green” features.
Even if installed, your screen saver does not display when you select
[Blank Screen] for the above field.
[V/H SYNC+Blank] blanks the screen and turns off vertical and horizontal
scanning. Configuration options: [Blank Screen] [V/H SYNC+Blank]
[DPMS Standby] [DPMS Suspend] [DPMS OFF] [DPMS Reduce ON]
HDD Power Down [Disabled] HDD Power Down [Disabled] HDD Power Down [Disabled] HDD Power Down [Disabled] HDD Power Down [Disabled]
Shuts down any IDE hard disk drives in the system after a period of
inactivity as set in this item. This feature does not affect SCSI hard drives.
Configuration options: [Disabled] [1 Min] [2 Min] [3 Min]...[15 Min]
ACPI Suspend To RAM [Enabled] ACPI Suspend To RAM [Enabled] ACPI Suspend To RAM [Enabled] ACPI Suspend To RAM [Enabled] ACPI Suspend To RAM [Enabled]
Allows you to enable or disable the ACPI Suspend-to-RAM feature. To
support this feature, the +5VSB of the power supply should provide more
than 720 mA current. Configuration options: [Enabled] [Disabled]
Suspend Mode [Disabled] Suspend Mode [Disabled] Suspend Mode [Disabled] Suspend Mode [Disabled] Suspend Mode [Disabled]
Sets the time period before the system goes into suspend mode.
Configuration options: [Disabled] [1~2 Min] [2~3 Min] [4~5 min] [8~9 Min]
[20 Min] [30 Min]
PWR Button < 4 Secs [Soft Off] PWR Button < 4 Secs [Soft Off] PWR Button < 4 Secs [Soft Off] PWR Button < 4 Secs [Soft Off] PWR Button < 4 Secs [Soft Off]
When set to [Soft off], the ATX switch can be used as a normal system
power-off button when pressed for less than 4 seconds. [Suspend] allows
the button to have a dual function where pressing less than 4 seconds puts
the system in sleep mode. Regardless of the setting, holding the ATX
switch for more than 4 seconds powers off the system.
Configuration options: [Soft off] [Suspend]