Asus Pundit P2-PE2 - Manual (Page 61)

5 - 1 3 5 - 1 3 5 - 1 3 5 - 1 3 5 - 1 3 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2 A S U S P u n d i t - P E 2
5.3.1 5.3.1 5.3.1 5.3.1 5.3.1 Primary and Secondary Master/Slave Primary and Secondary Master/Slave Primary and Secondary Master/Slave Primary and Secondary Master/Slave Primary and Secondary Master/Slave
Type [Auto] Type [Auto] Type [Auto] Type [Auto] Type [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, setup automatically fills in the correct values for
the remaining fields on this sub-menu. If automatic detection fails, this may
be because the hard disk drive is too old or too new. If the hard disk was
already formatted on an older system, setup may detect incorrect
parameters. In these cases, select [User Type HDD] to manually enter the
IDE hard disk drive parameters. Refer to the next section for details.
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
Multi-Sector Transfers [Maximum] Multi-Sector Transfers [Maximum] Multi-Sector Transfers [Maximum] Multi-Sector Transfers [Maximum] Multi-Sector Transfers [Maximum]
Automatically sets the number of sectors per block to the highest number
that the drive supports. When this field is automatically configured, the set
value may not always be the fastest value for the drive. Refer to the
documentation that came with the hard drive before setting this item to
the optimum value. Configuration options: [Disabled] [2 Sectors]
[4 Sectors] [8 Sectors] [16 Sectors] [32 Sectors] [Maximum]