YSI Data Scout Advanced - Manual (Page 63)

YSI Incorporated Data Scout Advanced 59
Figure 4.48
Since these coefficients can only be viewed, clicking OK will cause a Beep (or Bell) to sound indicating that the coefficient was not
changed. Select Cancel when finished viewing a particular coefficient’s current value.
When the above window is closed, the previous coefficient selection window is then repeated. Select another single coefficient to view
or select Cancel if
finished viewing coefficients.
The Configure | Sleep Mode (HiLi Xdcr) menu item opens the following window:
Figure 4.49
If Sleep Mode is enabled (factory default) then the battery saving features of the Level Scout are enabled, and all commands sent to the
transducer must be prefixed by the special SDI-12 serial port Break/Mark sequence (see Advanced properties of the Xducer Site Net
Com Port configuration window). Only when such a “prefixed” command is completed does the transducer enter the Sleep state again
to conserve battery power. If Sleep Mode is disabled then the use of the Break/Mark sequence is optional but battery consumption
may also become excessive. Therefore, always use an external power source with the transducer that has Sleep Mode disabled.
The current Sleep Mode state (enabled/disabled) of the transducer is indicated by the option button selected. Select the desired state
by clicking the corresponding option button and then click OK to change it.
The Configure | Update Firmware (HiLi Xdcr) menu item is described fully in section 4.2.7.