John Wood Takagi - 110-310-510 - Manual (Page 17)

17
Remote Controller Connections
To connect the remote controller to the water heater:
1. Disconnect power supply from the water heater.
2. Take off the water heater’s front cover.
3. Locate the remote controller terminal, pictured below
(located around the lower right-hand side of the com-
puter board).
4. Open the plastic cover of the remote controller, and then
attach the two fork terminals to connector base of the
backside the remote controller with two screws. Make
sure the terminals are firmly fixed.
5. Pull the remote’s wires through the hole at the bottom of
the water heater’s casing.
6. Properly attach the remote’s wires to the remote control-
ler terminal on the computer board. (No polarity)
* Do NOT jump or short-circuit the wires or computer will
be damaged.
7. Replace Front Cover securely.
8. Wires used for the remote controller connection must
be:
Minimum 18AWG wire (No polarity)
Maximum 122m (400 ft.) long
* For detailed connection instructions to the remote con-
troller, refer to the instructions that are packaged with the
remote controller.
•
•
Connect to
these terminals
TK-RE02
Front of
remote
110 & 310 models
Back of
remote
Connect other end
to these terminals
510 models TM-RE30
Front of
remote
Back of
remote
Connect other end
to these terminals Connect to
these terminals