Extron Electronics MP 101 Series User Guide - Manual (Page 17)

2-9 MP 101 Series • MP 101
b. At each mark, drill a 3/32" (2 mm) diameter pilot hole
approximately 0.25" (6 mm) deep in the mounting
surface.
c. Insert provided #8 wood screws into the four pilot
holes. Tighten each screw into the mounting surface
until just less than 0.25" (6 mm) of the screw protrudes.
d. Align the bracket slots with the wood screws and place
the unit against the mounting surface.
e. Slide the unit either forward or backward until the
screws are in contact with the edge of the bracket slots.
Then, tighten each screw to secure the unit in place.
Adjusting the MP 101
After the MP 101 has been properly mounted and connected, do
the following to adjust it:
1. If using a condenser microphone, set the Phantom power
switch to the “on” position.
If using a dynamic microphone, set the Phantom power
switch to the “off” position.
2. When using the microphone for voice audio, fl ip the Low
Cut switch to “on” to reduce wind and “table rumble”
noise.
When using the microphone for music audio, fl ip the Low
Cut switch to “off” to preserve the optimum sound quality.
3. Set the Mic Gain potentiometer by saying a few words into
the microphone and adjusting for the maximum sound
level that is free of distortion.
N
If there is a remote control connection, unplug it while
adjusting the Mic Gain potentiometer. Replace the remote
control when fi nished.
If there is minimal distortion, but greater volume is required,
turn the Mic Gain potentiometer clockwise (towards the 75
dB mark) to increase the volume, but not past the point where
distortion occurs.