Extron Electronics MP 101 Series User Guide - Manual (Page 21)

3-3 MP 101 Series • MP 101 AAP
b
Phantom power switch — Provides switchable 48 volt phantom
power for condenser microphones.
Audio output (line level)
c
Line Output — A 3-pin, captive screw connector outputs to
audio mixers, amps switchers, or other non-microphone audio
equipment.
Unbalanced Output
(high impedance)
Tip
Sleeve
NO Ground Here
CAUTION
For unbalanced audio, connect the sleeve(s)
to the ground.
DO NOT connect the sleeve(s)
to the negative (-) contact.
(5 mm) MAX
Captive Screw
Connector stripping
3/16"
Tip
Sleeve
Ring
Balanced Output
d
Low Cut fi lter switch — Provides low cut fi ltering to remove
wind and “table rumble” noise.
Remote connection
e
Remote — An optional 3-pin, captive screw connector allows
a wall mounted audio controller or MediaLink product to
remotely control volume and mute levels for the MP 101
unit. See “Remote Control”, later in this chapter, for more
information.
Front Panel Features
MIC
IN
ACTIVE
MUTE
MLP 101 AAP
2 1 4
3
a
XLR mic input — Use an XLR connector or a standard
microphone connection. See the following illustration and table
for connector pin out information.