B&K Precision 2542B-GEN - Manual - Manual (Page 208)

Quick Start Guide
208
Perform the following steps to output the amplitude
modulated waveform.
 Connect the WG Output teminal to CH1 terminal.
 Press ON/OFF key to enable signal output.
 Press the MENU key to display the arbitrary waveform
generator menu.
 Press Output Type softkey to select AM modulation.
 Press Carrier Freq softkey to select and specify the
carrier frequency to 10 kHz.
 Press Carrier Ampl softkey to select and specify the
carrier amplitude to 600 mVpp.
 Press More 1/2 softkey to display the AM menu page
2/2.