B&K Precision 2542B-GEN - Manual - Manual (Page 217)

Troubleshooting Guide
217
Empty storage memory: This message will be displayed
when you try to load a file which does not exist from the
internal memory.
Unrecognized file: This message will be displayed when you
try to load a file which can not be recognized by the
oscilloscope from the external memory.
Update failed: This message will be displayed when
firmware update has failed.
No record data: This message will be displayed when you
try to save or playback a record without recorded data.
Record is aborted: This message will be displayed when
Operate softkey is pressed to stop record process without
any waveform data recorded.
Factory setup is recalled: This message will be displayed
when the default factory configuration is recalled.
No signal is found: This message will be displayed when
you press the AUTO key without any signal connected to
each channel.
Invalid data: This message will be displayed when you try to
save a *.CSV , *.TRC or *.WFM file without any valid
waveform data.