B&K Precision 2542B-GEN - Manual - Manual (Page 87)

Menu Operation
87
networks. Move the cursor to the Gateway IP position
and enter the gateway address in the IP address format
using the entry knob.
 Set the DNS IP. DNS is an internet service that
translates domin names into IP addresses. Move the
cursor to the DNS IP position and enter the address of
the DNS server in the IP address format using the entry
knob.
Note: If you are manually entering the LAN settings,
you may need to restart the oscilloscope for
settings to apply. If you are using DHCP, first
turn on DHCP, then select OK and wait a few
seconds until the Configure Status shows
“DHCP”. Otherwise, it may not be able detect the
correct DHCP settings from the connected
network. We recommend configuring with
DHCP.
Note: The instrument does not support socket or telnet
connection. When interfacing over LAN, if
settings were changed or refreshed (from
selecting OK from softpanel menu), the
instrument may need to be rebooted first before it
can be connected for remote control.