B&K Precision 8500-8526 - Manual - Manual (Page 2)

Safety
The following general safety precautions must be observed during all phases of operation of this instrument.
Failure to comply with these precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacture, and intended use of the instrument. B&K Precision assumes no liability for
the customer’s failure to comply with these requirements.
Verify that all safety precautions are taken. Note the instrument's external markings described under "Safety
Symbols".
This product is a Safety Class 1 instrument, which means it is provided with a protective earth terminal. To
minimize shock hazard, the instrument chassis and cover must be connected to an electrical ground. The
instrument must be connected to the AC line power through a grounded power cable, with the ground wire
firmly connected to an electrical ground (safety ground) at the power outlet. Note: Any interruption of the
protective (grounding) conductor or disconnection of the protective earth terminal will cause a potential shock
hazard that could result in personal injury.
DO NOT OPERATE THE INSTRUMENT IN AN EXPLOSIVE ATMOSPHERE OR IN THE PRESENCE OF
FUMES OR FLAMMABLE GASES.
KEEP AWAY FROM LIVE CIRCUITS.
Operating personnel must not remove instrument covers. Component replacement and internal adjustments
must be made only by qualified service personnel. Do not replace components with the power cable
connected. Under certain conditions, dangerous voltages may exist even with the power cable removed. To
avoid injuries always disconnect power, discharge circuits and capacitors, and remove external voltage
sources before touching components.
DO NOT SERVICE OR ADJUST ALONE.
Do not try to perform internal service or adjustment unless another person capable of rendering first aid and
resuscitation is present.
Safety Symbols
Note the instrument's external markings as follows:
Direct current
Alternating current
Both direct and alternating current
Protective earth (ground) terminal
Caution (refer to accompanying documents)
WARNING
The WARNING sign denotes a hazard. It calls attention to a procedure, practice,
or the like which, if not correctly performed or adhered to, could result in
personal injury. Do not proceed beyond a WARNING sign until the indicated
conditions are fully understood and met.
CAUTION
The CAUTION sign denotes a hazard. It calls attention to an operating
procedure, or the like, which, if not correctly performed or adhered to, could
result in damage to or destruction of part or all of the product. Do not proceed
beyond a CAUTION sign until the indicated conditions are fully understood and
met.
8500 DC Load Series Version: 030614 Page 2 of 77