I-View AnyNet-0401Mini Embedded NVR - Manual (Page 12)

12
Chapter 2. Hardware Installation
Please use the HDD which supports 7200 RMP or above and the same model when you use
the Raid 5 or 6 mode.
Install Hard Disk Drive
Remove Hard Disk Drive
Remove top cover of NVR
①
Pull the lever to latch HDD tray .
②
Slide tray from HDD tray.
① Remove protect tray from the tray.
② Insert the HDD on the tray.
③ Attach with 4 screws to fix HDD.
④ Push the lever to latch HDD tray.

①
Release two screws on the back side and twp
screws on both left and right side.
②
Thumb finger touch downward, and then push
back the rear back cover.
③
Put hand on the front top cover pull it out.