I-View AnyNet-0401Mini Embedded NVR - Manual (Page 125)

125
5-6.
ezUPSCheck
If the user installed the UPS with NVR for power management purpose, the user can set up the actions to take
for NVR when there is not enough power capacity for UPS or when the electricity is come back to the NVR.
Please follow the steps below for setup.
Step 1.
Click “ezUPSCheck” from “ezTools”
Step 2.
Check “Enable auto run system” to
automatically run “ezUPSCheck” when you
turn on the PC.
Step 3.
Check the UPS status. If the UPS is well connected to NVR, the status of UPS will be automatically
shown on “ezUPSCheck” window.
Step 4.
Click “Set up ezUPSCheck” for function selection.
Step 5.
Auto exit Witness Pro program when UPS power is less than: The system will auto save the
current video and exit Witness Pro when the UPS power is less than the set percentage.