I-View AnyNet-0401Mini Embedded NVR - Manual (Page 42)

42
Areas Setup – Select or frame the specific areas from the view of the camera for motion
detection.
To add a new area of detection, please follow the steps shown as below:
Step 11.
Flame and drag on the video image to select the desired detection area by your mouse.
Step 12.
Click button to add the new selection.
Step 13.
To set up others detection areas, repeat step 1 and 2.
Step 14.
Choice the sensitivity level for the detection.
To delete a pre-set detection area, follow the steps shown as below:
Step 15.
Select a detection area by right clicking on it. This area will become blue.
Step 16.
Click “Delete area” button. This area will be disappeared from view.
Step 17.
To delete other detection areas, repeat step 1 and 2.
If you don’t define specific detection areas, the entire view of the video will be the detection area.
Hardware detection (Optional) – You can use hardware detection for more accurate motion
sensing. For example, light changes do not trigger false alarms, but it does with software detection.
You can select a motion-sensing device from “Triggered by” drop-down menu. Once you connect
the sense devices at the “Sensor in” ports of the optional “inputs board” (NVR add-on) or IP
camera, a motion sensor will be triggered due to detected movement in its track and the assigned
camera will automatically create an alarm and start to record.
Illegal parking setup: (Optional)