CEMB USA DWA 1000XLB - Manual (Page 27)

I 0645 28
=
GB
6.1 - How to execute runout
Starting conditions:
Position the vehicle with the front wheels on the turn plates, the steering wheel straight, the parking •
brake disengaged and the gear in neutral.
Lock the turn plates and the rear slip plates
•
Position wedges or other safety devices if necessary •
Press 1. (180° runout lifted), (3x90° runout lifted), (180° runout on the ground) or (90°
runout on the ground) to select the desired runout method.
Mount the wheel clamps so that the handle is in the reference position, for example, the position sugge- 2.
sted on the display (for trucks only: mount the wheel clamps on the wheels indicated by the arrow)
Fit the measuring heads without tightening the handles so that they are free to turn (for trucks only: fi t 3.
the front measuring heads where indicated by the orange arrows and the rear measuring heads where
indicated by the blue arrows)
Follow the instructions in the following paragraphs according to the runout method selected 4.
S 5. ettle the suspension
Position the brake pedal lock 6.
Press 7. . An image will appear to remind you to position the brake pedal lock
Again press 8. or wait a few seconds before going to the next step
The image of the wheel shows the wheel clamp handle as seen by the operator when looking •
at the wheel.
If execution errors are signalled during the runout procedure, follow the on-screen instruc •
tions and, if requested, repeat the procedure. Otherwise, the result might be inaccurate.
(truck): Fit the front measuring heads as indicated by the orange arrows and the rear •
measuring heads as indicated by the blue arrows.
Initially, you can also position the clamps handle differently from that suggested for example to facilitate
securing any support arms, but than the direction and angle of rotation of the wheel must be respected.