CEMB USA DWA 1000XLB - Manual (Page 43)

I 0645 44 GB
Press 4. . The following appears:
Adjust the toe-in by acting on the upper head 5.
Press 6. and the following appears:
Lift the vehicle, remove the VAS tool, lower the vehicle and settle the suspension 7.
Press 8. to go to the Front Adjustment page
9.7 - Adjusting with the wheels raised or steered (freezing)
If it is diffi cult to access the adjustment points, for example, because the vehicle is on the ground or the
adjustment point is hidden by parts of the suspension, you can use the "freezing" procedure to adjust with
the vehicle lifted or the wheels steered.
Freezing is particularly useful in the case of a 2-column car lift
The Freezing procedure consists of storing ("freezing") the measurements with the vehicle lowered and the
wheels straight in order to keep them unaltered also after the vehicle has been lifted or the wheels stee-
red. Thus you can adjust the angles to within the specifi ed tolerances as if the vehicle were still lowered
with the wheels straight.
This procedure can be activated on both the Front Adjustment and the Rear Adjustment page.
Starting from an adjustment page:
Press 1. to freeze the measurements. The graphics shows that the measurements have
been frozen