ALLIED Vision Technologies Pearleye P-030 LWIR - Manual (Page 25)

Camera interfaces
Pearleye Technical Manual V2.3.0
25
Camera interfaces
This chapter gives you information on the control junction, inputs and outputs
and trigger features.
Control connector
Camera I/O connector pin assignment (15-pin
D-sub connector)
This connector is intended for the power supply as well as for controlling the
camera via its serial RS232 interface over a COM port.
Furthermore, some output signals are available, showing the camera state.
www

For accessories like cables see:
http://www.alliedvisiontec.com/emea/products/
accessories/gige-accessories.html
Pin Signal Direction Level Description
1
External Power +12 V DC (-0% / +5%)
Power supply
max. 1.5 A 2
3
External GND
4
5 --- Reserved
(do not connect)
6 --- Reserved
(do not connect)
7 RxD In RS232 Camera control
8 TxD Out RS232 Camera control
9
--- Reserved
(do not connect)
10 Trigger (Reset)
input -
optocoupler input
11 +
12 Sensor tempera-
ture too low - optocoupler output
13 +
Table 7: Camera I/O connector pin assignment