ALLIED Vision Technologies Pearleye P-030 LWIR - Manual (Page 80)

Appendix
Pearleye Technical Manual V2.3.0
80
CameraSpecialFeatures
Feature Description
AutoCalibrateOnce Start the automatic calibration once.
(k=0 command)
The processing of this command can take several seconds,
depending on the current image rate and the number of
correction data sets available.
AutoCalibrationMode Configure mode of the automatic calibration function.
( j=<value> command)
AutoCalibrationInterval Setup the automatic calibration interval. 0 = Calibrate one-time,
1..65535 = Calibrate every k*256 frames.
(k=<value> command)
CorrectionDataSet Number of the correction data set to activate.
(S=<value> command)
ReloadCameraSpecialFeatures Force a reload of all parameters from the CameraSpecialFeatures
section.
Table 39: Camera special feature: Calibration and correction data
Feature Description
CameraTemperatureState Camera temperature state.
0 = The camera temperature is OK.
1 = The camera temperature is outside the optimum range.
CameraTemperatureStateReg Camera temperature state register.
QueryCameraTemperatureState Query camera temperature state.
(T=1 command)
Table 40: Camera special feature: Camera temperature
Feature Description
ShutterTemperatureValue Shutter temperature value in degree Celsius.
ShutterTemperatureValueReg Shutter temperature value register.
QueryShutterTemperatureValue Query camera shutter temperature state.
(T=2 command)
MechanicalShutter Set the mechanical shutter state manually.
(I=<value> command)
Table 41: Camera special feature: Shutter