ADC Campus-REX2 RS - Manual (Page 40)

Chapter 2 - Configuring HDSL Parameters
28 Campus-REX2 RS Interface Card User Manual
3 To enable the Local Data Port LOS Alarm, type then press .
When enabled, an alarm is generated when a loss of signal is detected at
the data port on the local Campus unit. (To disable this alarm, repeat the
procedure).
4 To enable the Remote Data LOS Alarm, type then press .
When enabled, an alarm is generated when a loss of signal is detected at
the data port on the local Campus unit. (To disable this alarm, repeat the
procedure).
The new HDSL alarm settings take effect immediately after entered and a
save command is not required.
8 ENTER
9 ENTER