Setting the time and date, Identifying the unit and circuit – ADC Campus-REX2 RS User Manual
Page 79
Chapter 4 - Managing System Parameters
Campus-REX2 RS Interface Card User Manual
67
S
ETTING
THE
T
IME
AND
D
ATE
The time and date parameters provide a common time and date stamp
for system functions such as alarm indications or performance monitoring
histories.
1
To set the time, type
then press
.
2
At the prompt, type the time in a 24-hour format as shown below then
press .
ENTER NEW TIME (FORMAT HH:MM:SS):
16:34:09
The system displays this new time on System Parameters screen.
3
To set the date, type
then press
.
4
At the prompt, type two numbers for the day, two number for the month,
and the four-digit year, separated by slashes (/), then press
.
ENTER NEW DATE (FORMAT MM/DD/YYYY):
04/30/2003
The system displays this new date on System Parameters screen as
Apr 30, 2003.
System and date take effect immediately after the values are entered and a
save command is not required.
I
DENTIFYING
THE
U
NIT
AND
C
IRCUIT
A Campus system supports two different identifiers:
•
The Unit ID indicates an individual Campus unit which can be either a
desktop unit with an interface card or each interface card and line card
combination in a Campus-Star chassis.
•
The Circuit ID identifies the HDSL circuit between local and remote
units and is the same for both.
Do the following to set or change these identifiers.
1
From the System Parameters menu, type
then press
. At the
prompt, enter the Unit ID using a unique identifier up to 32 characters.
Maximum length is 32 characters.
ENTER NEW UNIT ID: Southall Quad 4
1
ENTER
ENTER
2
ENTER
ENTER
3
ENTER